Thanksgiving Cards with Country Lane Suite

Hello and welcome to today’s cards, which are part one of my three-part Thanksgiving cards made with the Country Lane Suite! With Thanksgiving right around the corner, going to Orlando for OnStage, and then family coming right after that, it was time to get on those cards! I chose the Country Lane Suite from the 2018 Holiday Catalog for my Thanksgiving cards this year, but where to start?? Sometimes when Designer Series Paper is a little “busy” it can be overwhelming and you may not use that side of the paper, but I wanted to challenge myself. Recently I watched a FaceBook video from Ronda Wade (8 cards in about 20 minutes, her page is @trainingwithrondawade) and she showed how to make 8 cards from one sheet of Designer Series Paper and I loved the simplicity of the cuts! Instead of taking my favorite design from the Country Lane DSP, I took a sheet that I probably would not use and cut it right up, which inspired me to make my 8 cards that I’m sharing with you.

You will start with a 12” x 12” sheet of DSP and cut it into three 4” strips. The first strip you will cut two pieces to 5 ¼” and save the scrap leftover. The second strip you will cut two pieces to 3”, one piece to 4”, and save the scrap leftover. The third strip you will cut one piece to 5 ¼”, one piece to 2”, and then save the leftover piece for accents:

fullsizeoutput_2c5d

You will also need four sheets of coordinating cardstock, so I used one sheet of Blackberry Bliss, one sheet of Thick Whisper White, and two sheets of Mint Macaron. The sheet of Blackberry Bliss and Thick Whisper White cardstocks were cut into two pieces measuring 5 ½” x 8 ½”, scored at 4 ¼”, and the Mint Macron sheets were cut into two pieces measuring 4 ½”x 11”, scored at 5 ½”.

For the card on the left, I used Blackberry Bliss cardstock for the card base, one sheet of DSP cut at 4” x 5 ¼” for the base layer:

fullsizeoutput_2c11

For the front of the card I stamped the sentiment from the Country Home stamp set in Blackberry Bliss ink on Whisper White cardstock and cut out with the second largest Stitched Shapes oval, I cut a piece of the Chicken Wire Element in half, used the biggest Stitched Labels Framelit to cut out in Crushed Curry cardstock, and you will need enough Braided Linen Thread to tie around the front panel into a bow:

fullsizeoutput_2c0e

To assemble the front, place a small amount of adhesive on the DSP to adhere the Chicken Wire Element, adhere the layered sentiment on top with dimensionals, and tie the linen trim around into a bow:

fullsizeoutput_2c14fullsizeoutput_2c18

The inside sentiment is on a piece of 4” x 5 ¼” Whisper White cardstock, the sentiment is stamped in Blackberry Bliss ink, and I cut the scrap leftover in half (this will give you two piece of ¾” x 4”) and adhered along the bottom:

fullsizeoutput_2c1b

For the card on the right, I adhered the leftover scrap for accents (measures 4” x 4 ¾”) to the Mint Macaron card base:

fullsizeoutput_2c48

The sentiment is stamped in Blackberry Bliss ink on Whisper White cardstock and cut out with the second largest Stitched Shapes square, adhered two of the Leaf Trinkets with glue dots, and embossed a 1 ¾” x 4” piece of Galvanized Metallic Paper with the Tin Tile Dynamic TIEF and used a sponge dauber with Early Espresso ink over it, which gave it a slight purple/pink sheen:

fullsizeoutput_2c4b

The embossed paper is adhered to the card base and then the sentiment is adhered with dimensionals:
fullsizeoutput_2c4e

The inside sentiment is on a piece of 4” x 5 ¼” Whisper White cardstock and the sentiment and shape are stamped in Blackberry Bliss ink:

fullsizeoutput_2c51

So, I made two of the card on the left and one on the right, which gave me 3 cards so far. On my next post I will show you the next two card that I made from this one sheet of DSP, so stay tuned!!

Wondering what specials are going on?? Current specials are listed to the right!!

Live in the USA? I would love to be your demonstrator! Contact me today to learn more about purchasing Stampin’ Up! products, hosting a party, joining my team or if you would like a complimentary catalog!

You can head over to my online store by clicking the Shop Now! button at the very top to see all available products and don’t forget to print out your shopping list on the righthand side, under Follow Me!

I hope today’s project inspires you to get creative! Please contact me if you have any questions about the products used on this or any other project. I hope you enjoyed today’s blog and thanks for stopping by!

Today’s Colors:


Product List

Fall Theme Blog Hop!

fullsizeoutput_263b

Hello and welcome to the Stamp It Groups Fall Theme Blog Hop! Can you believe the official start of Fall is only 3 weeks away?? Today’s blog hop is a great way to get your mind set (and ready) for the upcoming holiday card and craft making! The card I am sharing today features the Rooted in Nature stamp set with Mango Melody, Cajun Craze, Mossy Meadow, and Copper accents. This is a very easy card to CASE and change the colors used to make it your own creation!

To create this card, start with Cajun Craze cardstock, cut at 4 ¼” x 11”, and scored at 5 ½” for your card base:

fullsizeoutput_2623

The base layer is Very Vanilla cardstock, cut at 4” x 5 ¼”. I then used both of the leaf stamps from Rooted in Nature in Mango Melody, Cajun Craze, and Mossy Meadow ink. I stamped off the leaf stamp after inking and randomly stamped them on the Very Vanilla cardstock:

fullsizeoutput_2626

You will need a piece of Copper Trim long enough to go across the front of the card and one of the Leaves Trinkets in copper. From the Stitched Labels Framelits, I used the bigger of the two circle dies to cut out a piece of Cajun Craze cardstock and the label framelit to cut out the sentiment in Copper Embossing Powder on Very Vanilla cardstock:

fullsizeoutput_2629

The adhere the Very Vanilla sentiment across the middle of the Cajun Craze piece and then use glue dots to adhere the Leaves Trinkets:

fullsizeoutput_262c

Use some adhesive on the back of the base layer to secure the Copper Trim and I used some dimensionals to secure it on the front before adding the layered sentiment piece:

fullsizeoutput_262ffullsizeoutput_2632

I applied adhesive directly to the card base so when I set the base layer on top, it would have some extra adhesive to secure the Copper Trim:

fullsizeoutput_2635

The inside is a piece of Very Vanilla cardstock, cut at 4” x 5 ¼” and I stamped the larger leaf stamp in Mango Melody ink and the smaller leaf stamp in Cajun Craze and Mossy Meadow inks down the side:

fullsizeoutput_2638

Wasn’t that easy?? Another great color combo would be Crushed Curry, Pumpkin Pie, and Old Olive! Any sentiment from the Rooted in Nature stamp set could be used for this card, it just depends on the occasion!

The 2018 Holiday Catalog will be live September 5th, so if you would like a complimentary copy please contact me for more details!!

Wondering what specials are going on?? Current specials are listed to the right!!

You can head over to my online store by clicking the Shop Now! button at the very top to see all available products and don’t forget to print out your shopping list on the righthand side, under Follow Me!

Live in the USA? I would love to be your demonstrator! Contact me today to learn more about purchasing Stampin’ Up! products, hosting a party, or joining my team!

I hope today’s project inspires you to get creative! Please contact me if you have any questions about the products used on this or any other project. I hope you enjoyed today’s blog and thanks for stopping by!

This month’s contest:

fullsizeoutput_2620

And the winner from the Christmas in July Blog Hop is:

fullsizeoutput_261f

Don’t forget to scroll down to leave your name and a comment with #stampitcontest and keep on hopping to the next name on the Blog Hop tour:

Blog Hoppers

 


Product List

Thinking of you

Hello and welcome to today’s card, featuring the Nature’s Poem Suite, located on pages 142-144 in the 2018-2019 Annual Catalog. Notice anything different? The corners are rounded! Stampin’ Up! introduced the Detailed Trio Punch (page 211) and which includes a corner rounder! If you don’t have the Envelope Punch Board (or even if you do), this product is a must for adding details!

The card base is Soft Suede cardstock, cut at 5 ½” x 8 ½”, and scored at 4 ¼”:

fullsizeoutput_1f6d

I used these designs from the Nature’s Poem Designer Series Paper, cut at 4” x 5 and 2” x 5 ¼”:

fullsizeoutput_1f70

On a piece of Whisper White cardstock, stamp the trunk image from the Rooted in Nature stamp set in Soft Suede ink, stamping off first. Then using the sentiment from this stamp set, heat emboss in White Embossing Powder. The image on the right is embossed first and stamped second. I like the result on the left!

I fussy cut this from the Whisper White cardstock and roughed up the edges with the edge of my scissors:

fullsizeoutput_1f79

I used the Detailed Trio Punch to round the edges of the card base and the base layer DSP and then adhered the layers to the card base:

I cut a piece of the Burlap Ribbon, adhered that across, and then cut a piece of Nature’s Twine in Grapefruit Grove, working the strands apart on the ends:

fullsizeoutput_1f82fullsizeoutput_1f85

You can use dimensionals to keep the twine in place:

The sentiment is placed on top of the dimensionals, I used one of the leaves from the Leaves Trinkets, tying a doubled piece of Linen Thread in a knot, and used a glue dot to adhere:

fullsizeoutput_1f8e

The inside sentiment is on Whisper White cardstock, cut at 4” x 5 ¼”, stamped in Cajun Craze ink, and the leaves from the stamp set are stamped in Tranquil Tide and Cajun Craze inks:

fullsizeoutput_1f91fullsizeoutput_1f94

This a great quick and easy card, with just a few added details, that would be great to send to someone! Do you have anyone in mind you’d make and send this to?

You can head over to my online store by clicking the Shop Now! button at the very top to see all available products and don’t forget to print out your shopping list on the righthand side, under Follow Me!

Live in the USA? I would love to be your demonstrator! Contact me today to learn more about purchasing Stampin’ Up! products, hosting a party, or joining my team!

I hope today’s project inspires you to get creative! Please contact me if you have any questions about the products used on this or any other project. I hope you enjoyed today’s blog and thanks for stopping by!


Product List